Ring size guide

ring size guide

If you are unsure about the right size of your ring, Brosway offers you a simple guide for choosing the right size to buy. Buying a ring of the right size is never easy and especially if it is a gift it is essential to have a very accurate ring size chart.

There are several ways to understand which is the right size for your ring, you can choose between the ones we offer you, and then you will see which one you find most comfortable with. Follow our advice and if in doubt about any of our products you can contact us from the contact page.

ring size table

In the following table, you will find indications on ring measurements with reference to the National Standard System. Consult the table to find both sizes for men’s rings and sizes for women’s rings.

MEASURE THE DIAMETER WITH YOUR RING

To measure the internal width of the ring, the following materials are required:

STEP 1:
Find a ring that suits you.

STEP 2:
Place the ring on a ruler and measure the largest internal area inside the ring, from inner edge to inner edge. Round off to the nearest whole millimeter.

STEP 1:
Find a ring that suits you.

STEP 2:
Place the ring on a ruler and measure the largest internal area inside the ring, from inner edge to inner edge. Round off to the nearest whole millimeter.

TIP 1:
The choice of size depends on the style of the ring: if the ring has a thin and essential shape, the measurement taken is exactly the corresponding one.

TIP 2:
If the ring model is band or has bulky stones, it is preferable to choose a larger size than usual.

TIP 1:
The choice of size depends on the style of the ring: if the ring has a thin and essential shape, the measurement taken is exactly the corresponding one.

TIP 2:
If the ring model is band or has bulky stones, it is preferable to choose a larger size than usual.

MEASURE THE CIRCUMFERENCE

To measure the length surrounding the base of the finger you will need the following materials:

STEP 1:
Cut a long strip of paper 5mm wide.

STEP 2:
Wrap the strip of paper around the base of the desired finger. To get the most accurate result, roll the card as far as possible.

*Don’t worry, the ring won’t be so tight.

STEP 1:
Cut a long strip of paper 5mm wide.

STEP 2:
Wrap the strip of paper around the base of the desired finger. To get the most accurate result, roll the card as far as possible.

*Don’t worry, the ring won’t be so tight.

STEP 3:
Make sure the paper is overlapping and pulled tightly and mark where the paper strip meets.

STEP 4:
Measure the length of the paper strip in inch. Round off to the nearest whole millimeter.

STEP 3:
Make sure the paper is overlapping and pulled tightly and mark where the paper strip meets.

STEP 4:
Measure the length of the paper strip in inch. Round off to the nearest whole millimeter.